![]() ![]() To conclude, WinComm is a pretty efficient piece of software when it comes to testing a COM connection. In addition to that, this program lets you use an ASCII mode, cut text when sending, send heartbeat at a user-defined interval, add auto responders by inputting the name, receive and send packet. It is also possible to adjust COM timeouts, discard NULL bytes, abort read/write operations on error, monitor CTS and DSR output flow control, and make driver sensitive to DSR signal. From the settings panel it is possible to configure several connection parameters.įor example, you can input baud rate, enable or disable DTR and RTS control, and specify parity, stop bits, byte size, XON and XOFF limit and error character. Connect to the port, adjust multiple parameters, set up heartbeats and auto respondersĪs stated above, this application enables you to connect to a COM port and test it in various manners. This means that the Windows registry is not going to be updated with new entries, unless you approve them.Īnother important aspect is that you can easily place the program files to a USB thumb drive and run it from there on any computer you have been granted access to. ![]() The installation process can be bypassed altogether, as this product is portable. Comms” under the Configuration tab 4) In the Comms Setup tab: Set Comms mode to “Bluetooth” Set the Checksum to “NO” Set Controller to “2way + Remote” 5) Tap the RS232C tab Set the Baudrate to “9600bps” 6) Tap the OK button to save your changes 7) Tap the BACK button to return to the Main Menu This document contains confidential and proprietary information that remains the property of Carlson Software Inc.WinComm is a software tool that was developed specifically to aid people in testing, sending and receiving data through the COM port, set up auto responders and heartbeat packets. ![]() 102 West 2 nd Street Maysville, KY 41056 Phone: (606) 564-5028 Fax: (606) 564-6422 Sokkia SRX Robot Quickstart guide 1) Power on the SRX instrument and Level the instrument !!! Warning – your Sokkia SRX instrument must be running Firmware 31-29 or higher to use SurvCE 2.50 or higher If you are running an older firmware you will need to downgrade to SurvCE Version 2.09 then contact your local Sokkia Dealer for details on upgrading your Sokkia Firmware in your instrument 2) From the main screen tap the “CONFIG” button you can also press the “SETTINGS” button on the keypad 3) Tap on “5. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |